2002 Harley Davidson FXD Dyna Super Glide "need engine" Questions

...need to know the specs for fluids (oil & gear) on my 02' Dyna FXD Use Formula Plus or SYN3 in trans and primary and engine. Or HD 360 20W50 in engine. Try to stick to same oil brand all the time ...

...need to know the specs for fluids (oil & gear) on my 02' Dyna FXD On the '02 bikes, the engine, primary, and transmission came with Harley-Davidson SYN3 synthetic oil in all three areas. Three ...

...need an air wrench to remove the engine sprocket nut and the clutch nut unless you have a "locking bar" or something to wedge into the primary chain to lock the primary up so you can retorque the ...

...need to know which plug is for oil have 3 under the engine Two are the engine oil one is probably the tranny fluid. Lookin from the primary side u'll see a hex bolt that sits vertical near the bottom ...

...engine should fire but there is an issue and could be relative to poor intensity of spark, poor plugs, poor fuel delivery and finally poor TIMING. So you need to check the above one by one to confirm ...

...engine has been modified from factory specs) so I think you may need to increase the viscosity of the oil, run straight 50 oil as recommended by H-D if your in a climate that remains over 60 degrees, ...

...need a fully charged battery (so that you get accurate readings within a reasonable amount of time) and a good Digital Volt Ohm Meter. Start by setting the function selector switch on the meter to DC ...

...need to know how much oil in transmission 3) how much oil in primary The engine takes three quarts of oil with a filter change. Now, always check the oil after filling. The dipstick has two marks on ...

Just need to know the specs for fluids (oil & gear) on my 2010' Dyna FXD HD 360 20W50 or SYN3 in engine and SYN3 or Formula Plus in trans and primary. Stick to one brand and type of oil in engine

engine to determine the condition of the rigns. It may be time to replace the rings. As for the stalling, I doubt that it's loosing compression. It's probably the idle speed is adjusted too low or the