Question about Harley Davidson FXDWG Dyna Wide Glide Motorcycles
...front of the housing half. You must desolder the wires, replace the switch with a new one, and resolder the original wires to the new switch. Reassemble the throttle sleeve and switch housing halves. ...
...Replace this switch first. Since the front brake light works off this switch as well, it may fix the front brake light switch as well. If not, you'll have to take the right handlebar switch housing ...
...Front master cylinder. If you desolder the wires, you can replace the switch, resolder the wires. Put the switch housing back together being careful not to pinch any of the wires. Reassemble and ...
Question about Harley Davidson FXDWG Dyna Wide Glide Motorcycles
front brake light switch. Loosen the bolts that hold the front master cylinder on the handlebars and slide the assembly as close to the right handlebar switch housing as possible. If this does not put
Question about Harley Davidson FXDWG Dyna Wide Glide Motorcycles
...brake light stays on all the time. The front and back brakes are free and do not seem the be bound up. There is a sensor by the rear brake reservoir that has wires running to the rear of the bike. ...
Question about Harley Davidson FXDWG Dyna Wide Glide Motorcycles
...replace the pad pin/bridge bolt, verify that the pad spring tabs on the brake pad engages the pad springs in the pistons. THEN install newpads into the caliper with the directional facing down when ...
...check your fuse box. Check to see if the fuse has blown. If it is OK then you will need to check both the rear and front brake light switches. Chances are though it will either be the bulb or
Question about Harley Davidson FXDWG Dyna Wide Glide Motorcycles
...front and back would come on. no left/right signal or brake lights would come on. replaced the tsm. problems continue even though the brake light periodically work but still no signal lights. ...
Question about Harley Davidson FXDWG Dyna Wide Glide Motorcycles
...front brake Replace the rear brake light switch. I've run into this before as well. When checking the switch with an ohm meter, it appears good but it will not light the rear bulb. The front brake ...
123 questions posted
Usually answered in minutes!
230 Questions
107 Questions
104 Questions
30 Questions
20 Questions