...lift out the circuits you may need circling pliers.then pull the top and bottom of the fork apart quickly.it will separate.then change the seals and put it back together you need to install the new ...
...lift the bike onto the center stand which will make the forks extend. Refill through the top of the fork with 12 oz of fork oil. The manual states that you must use oil with a weight of approximately ...
Question about Harley Davidson FXD Dyna Super Glide Motorcycles
fork but hey feel anchored to something Be careful with them they are under pressure from the springs make sure to lift the front off the ground, or remove forks from the bike. If the forms are upside
Question about Harley Davidson FXD Dyna Super Glide Motorcycles
...lift the front wheel by putting a jack under the motor. Remove the front wheel and axle and put a pie tin under the fork tube. Reach up into the bottom of the fork tube with a hex key and loosen the ...
Question about Harley Davidson FXD Dyna Super Glide Motorcycles
fork stem nut. 11. Lift handlebars from steering head with upper triple clamp attached. Be careful not to pinch or kink control cables. 12. Remove adjusting nut, seal, and upper bearing out of bearing
Question about Harley Davidson FXD Dyna Super Glide Motorcycles
...lift your front wheel off the ground. Remove calipers and front wheel. Slide the forks back down carefully ensuring they drop out all the way and smash radiator. Use vernier caliper to measure amount ...
Question about Harley Davidson FXD Dyna Super Glide Motorcycles
...oil height with the fork compressed and spring removed. Pour 5 weightfork oil in until itis 90 mm from the top. lift and lower the damper rod inside the tube a couple times and recheck your oil
...fork or two. Replacing the bad shift forks is major surgery and is NOT recommended for the inexperienced mechanic. Several special tools are needed. The top end and gearbox get totally torn down just ...
Question about Harley Davidson FXD Dyna Super Glide Motorcycles
...lift the bike off the ground. Remove the top cap from each tube and refill the fork tubes with the proper amount of oil for a "wet" oil change. Sorry but I don't have that information but it will be ...
64 questions posted
Usually answered in minutes!
137 Questions
126 Questions
109 Questions
45 Questions
21 Questions