2001 Harley Davidson FLHRCI Road King Classic "tension suppose set" Questions

...set the thumb cruise control on my 2001 Road King Classic, but how does it release without backing the screw off by hand? You answered your own question. Its technically not supposed to be used as a ...

...suppose to be a spring in there? What holds it from virbrating out? I was tolded These are set at the factory. What can I do? The bike is a 1995 HD FLHR Road King. It has a S&S (E) Carb. This sounds ...

...adjusts the chain and the outer nut is to lock down the inner nut. Also note the "pins" on the two tensioners ( #7 ). Be sure to tighten up the axle bolt after setting the chain tension. If the ...

tension of the adjuster don't remove the holding pin until the new adjuster is mounted once install pull the pin (holding clip) and the adjuster will set itself to the chains they cost about 65.00

...set the tension on a hot primary chain. But, if you say you heard a crunching noise, then the engine started running rough and popping out the exhaust, I'd suspect something to do with the ignition ...

...set them to a tight drag, about .001 under, but I verify the clearance, twice . When you do the left side, don't forget to loosen the 10mm cam chain adjusting nut one turn (in front of the flywheel ...

...of the air the diaphragm positions the needle. Try the easy checks first. Finally main chain tension. Follow the solution given by Fixya GURU ...

...set the sag on my cr250 and cant seem to get it. Sag is supposed to be approx 100mm. (4in.) Is this right? When I started it was at about 2 inches. So I back off the collars against the spring and ...

...it up or down anymore than a 1/2, then you'll need to tighten it. Adjust both sides of the chain tensioner equally, and you should be