...tried it on neutral and on first using the clutch but it does not crank. What should I look for or try. Check that the cable from your battery to the starter motor is not corroded and maybe
...starter button it the volts drop to around 10. What am I failing to do, any suggestions will be appreciated, I really want to be the one that gets this thing running agian. thanks, any suggestions ...
...starter) check voltage at starter solonoid on battery side if no then check clutch switch, sidestand switch, key switch. If yes then check for 12 volts on starter side when clutch pulled in, key ...
...starter button is hit, then check the battery, make sure it is good, then if all this checks out, check the wiring. If it is still a bad starter, remove the crank case cover on the left, rotate the ...
...Starter motor turns but no spark: check/replace sparkplug; check pulsating voltage on green/white wire going to ignition coil coming from the ignition control unit; check pulsating low AC voltage on ...
...check the power input and grounding of the starter. Most new bikes have a clutch switch, and it may interrupt the 12vdc to the starter, without affecting the relay. Same thing goes for the nuetral ...
Question about TVS Motorcycles
...starter. Check the starter motor: If the starter motor is not functioning properly, it may be causing the self starter to fail. You may need to replace the starter motor if it is damaged. Check the ...
Question about BMW R 1200 ST Motorcycles
...Check out the starter circuit (wiring, connectors, safety switches/relays, etc.) to get familiar with where everything is located on the bike. Check that the battery is fully charged. Hook up a ...
Question about BMW R 1200 ST Motorcycles
...starter, check or replace brushes, clean and check for continuity in your commutator(cooper part), Check for continuity between the housing(exterior part of the starter)and the cable terminal. If you ...
Question about BMW R 1200 ST Motorcycles
suggestions Check battery, check connections corrosion causes bad connection. Double check starter button switch, it may be bad. You may be able to verify this switch by "jumper" bypass of the switch.
3 questions posted
Usually answered in minutes!