Question about BMW R 1150 RT (ABS Motorcycles
Anybody have a comprehensive guide to replacing the clutch on an R1150 BMW? There are a few write ups over at BMW Sporttouring.com Use the search feature there to look. Other option is to buy a ...
How do I jump start my 2004 R1150RT-P? The battery seems to be covered up by some fairings. What do I have to remove in order to expose the battery terminals so I can jump start the dead battery? with
Question about BMW R 1150 RT (ABS Motorcycles
2002 1150 rt will not idle without choke on ,even after say 5 minutes and oil temperature is reading 5bars Hi, your problem could be either fuel or an air leak. I would sugest you aproach this problem
...remove the fairing by pulling it straight ahead away from the brackets. Installation First loosely position the outer fairing in place over the inner faring with the four studs going into the two ...
...Remove the fairing cap. Remove the outer fairing as follows: a. Standing at the front of the vehicle, use a T27 TORX drive head to remove the three outer fairing screws (with flat washers) just below ...
...fairing to remove the fairing. Get out you digital camera(any camera will do) and take frequent pictures as you remove fasteners. If you are unfamiliar with the correct re-installation location use a ...
Question about BMW R 1150 RT (ABS Motorcycles
...remove my fairing to replace the headling bulbs? Do I need to remove my fairing to replace the headlight bulbs on my 2004 Harley Road Glide? Hi there, well you can please follow the below steps - ...
Question about BMW R 1150 RT (ABS Motorcycles
...fasteners between upper and lower fairings so upper fairing can be removed c)remove windshield d) remove mirrors (which hold on upper fairing) e) remove and replace headlight bulb f) replace ...
...Remove the fairing cap from the motorcycle. 8. Locate the ignition switch connector (33), 4-place Packard, at bottom of radio. Slide connector off anchor and separate pin and socket halves. 9. Remove ...
...two screws under the fairing cap. Remove the three windshield screws you loosened before. Lean the outer fairing forward and undo the headlight connector and then lift the outer fairing from the
33 questions posted
Usually answered in minutes!
117 Questions
48 Questions