1993 Harley Davidson FXR Super Glide "installing tappets" Questions

how do i install s&s quicky push rods into 80 evo To begin with, I assume you already have the old pushrods out. If you plan on cutting the old ones out, cut them with a pair of bolt cutters, not ...

how do i adjust screaming eagle pushrods I think the SE pushrods have a 32 TPI pitch on the threads. If so, with the tappet all the way down in it's bore, adjust the pushrod longer until it make ...

...tappets bleed down. Once you can spin the pushrods in your fingers. Finish installing the pushrod tubes. Now, this is accurate provided your pushrods have a 32 threads per inch adjuster. If not, you ...

2006 XL1200 I just did the heads lifter and rods, cant get oil up to top end have cycled engin several times. lifters not primeing. Are you getting any oil back to the tank from the oil pump? ...

2000 dyna super sport started knocking, then back fired. Now a loud knocking, rough idle, and oil comes from the top of the engine. any thoughts? My first guess would be that you lost the roller ...

ticking noise i think in top end,not bad but im concerned,almost sounds like tappet tickin. bike has 28kthous. and just had hyd-cam tench and heavy oil pump installed about 4,000 ago. still has great ...

I have a 1988 HD Springer Softtail and have purchased a set of Andrews E-Z insall pushrods. I need to know how far down to go and how many turns up I need to go. I also need to know if I need to turn ...

how to adjust valves on 97 harley fatboy motor has a tick or peck in the back cyl. is there an adjustment for the valves? this cont after the motor warms up. There is no adjustment on the tappets in ...

One of the cams came out when I removed the side case from my 2005 XL1200 the tappet dropped down and I cant get the cam back in because the tappet is under pressure from the valve spring. Is their a ...

...installing new tappets? If you have a bad tappet, it's probably ruined the cam as well. If a roller locks up it will gall the cam lobe that it runs on which means the cam will have to be replaced ...