Question about Harley Davidson XLH 1000 Sportster Motorcycles
starter not always turning motor replaced starter selinoid,starter,battery,sounds like starter drive not fully engadging with crank at all times,this is on a 1973 Harley Sportster xlh Possible ...
Question about Harley Davidson XLH 1000 Sportster Motorcycles
set oil pump breather timing 1976 sportser On the shaft housing of the pump that goes up into the gear case, there is a "window" or little cut out place. With the cams installed and timed, slide the ...
Question about Harley Davidson XLH 1000 Sportster Motorcycles
tring to time oilpump but when hole on oilpump shaft is inline the timing mark moves out of timing hole working on harley 63 sportster Bring the engine to top dead center and find a way to lock the ...
aligning crankshaft marks Camshaft timing procedure for 1982 harley davidson xlh 1000 cc On the pinion gear there is a timing mark. This mark will line up with the rear cylinder intake cam. There are ...
Question about Harley Davidson XLH 1000 Sportster Motorcycles
how do u set the timing on a oil pump for a 76 harley sportster xlh 1000 lay down pump On the oil pump shaft housing, just below the gear, there's a small square slot cut out of the housing. If you ...
Question about Harley Davidson XLH 1000 Sportster Motorcycles
i would like to know if a 1977 xlh timing on the pinion gear has to be set one tooth off to run i read this on the internet . i took cam cover off and front cylinder exhaust pop out off timing, put ...
Question about Harley Davidson XLH 1000 Sportster Motorcycles
I am trying to find the timing mark on an 82 XLH Ironhead sportster I was told to put the bike in 4th gear and rotate the rear wheel until the mark appears. 2 things bike turns over and pistons move ...
Question about Harley Davidson XLH 1000 Sportster Motorcycles
Does the t.d.c mark have to be in the inspection window when replacing the cams/gears when re-building the engine I can't get the timing mark to line up exactly? Nice bike. I have an XLCH1000 If the ...
Question about Harley Davidson XLH 1000 Sportster Motorcycles
1982 harley davidson sportster, the correct alignment of pinion shaft and cam gears I assume you want a diagram of how to time the cams on your Sportster. Contact me directly at [email protected] ...
Question about Harley Davidson XLH 1000 Sportster Motorcycles
my xlh 1000 jumps out of 2nd and 3rd gear when under a load Hi Anonymous, and the usual suspects are: 1. Shifter pawl improperly adjusted. 2. Shifter drum improperly adjusted or damaged. 3. Shifter ...
382 questions posted
Usually answered in minutes!
681 Questions
595 Questions
586 Questions
644 Questions
456 Questions