how do i know if my bike has a bad valve. Take a compression check. If one cylinder is a lot lower (more than 10%) than the other chances are you either have a bad or leaking valve. Try to loosen the ...
Question about Suzuki LS 650 Savage Motorcycles
...loud when i turn her off. Ive cleaned out the carb fully and reset the exhust valves . I did a compression test and is only at 55psi.. now ither thats not good or the valves are stuffed. If any ...
Question about Suzuki LS 650 Savage Motorcycles
1999 kAWASAKI LS 650 - Is compression reading of 90 psi to low. Yes, it is too low. The minimum normal compression is 125psi. The range is from 125psi to 150psi.
...you may have a crankcase pressure problem from blow by. This is generally indicative of failing compression rings or worn piston/sleeve/rings in combinations. Do a compression test of the engine. ...
...it looked like. My bike had been down for a week after taking off the carb and cleaning it. The compression cable broke at the same time. After replacing it and putting the bike t back together, ...
suzuki 1987 wont run its getting gas and cranking over and has spark but still wont run any ideas has it got good compression if not id say piston rings
Question about Suzuki LS 650 Savage Motorcycles
...1 any ideas? replaced CDI, adjusted carb, ignition coil could be a bad valve intake side of headdoa compression test to make sure cylinders or reading above 100 lbs per ...
...just loosening the lock nut and adjusting the screw to the specified clearance at top dead center compression. hope this helps. thank
Question about Suzuki LS 650 Savage Motorcycles
its an 01savage. just had head gasket replace but now has a compression issue. rings are in good shap. question is it said to not use rtv on the seal. is that the issue? Recheck valve timeing, if you ...
40 questions posted
Usually answered in minutes!
51 Questions
39 Questions
24 Questions
23 Questions
23 Questions