2007 Ridley Auto Glide Chopper "put new throttle cable 2003" Questions

...new rider and in 2 weeks have racked up over 800 miles. While impressive the loss of power on the highway was a major scare. I have a 2003 model AutoGlide However the bike did have aftermarket risers ...

...new brake cables and throttle cables put on. They also replaced gasket in transmission. now i have a whining sound in 4th gear only and is getting louder. What's up?? it does not do it in 3rd or 5th ...

...new rider and in 2 weeks have racked up over 800 miles. While impressive the loss of power on the highway was a major scare. I have a 2003 model AutoGlide However the bike did have aftermarket risers ...

...to the new switch. Make sure you get the throttle assembly back together correctly and that it works properly. Don't pinch any wires when putting the switch housing back together Good Luck ...

...new grip and apply a coating of white lithium grease to the wheel part and the inside of the throttle sleeve in the grip. Put a coating of grease on the handlebar end where the sleeve rides as well. ...

...new but i think the guy i got it from may have put 90W in the trans i know the factory recommends 80W or 85W would this be causeing the problem. I checked the cable made some adjutments and it still ...

...put the clutch on biting point it just cuts out. Hope this makes sense. Can anyone help? Do a gearbox oil change. Then do another one 50 miles later. This should flush out the dirt and grit currently ...

...put it in gear and release the clutch slightly the bike idle drops to a lower level and stays low until i accelerate again. What can I do to stop this. (Manual Choke) Make sure that when the choke ...

put the new chisel end into the inlet side of the carb and under the bottom edge of the slide. Tap the end of the brush with a plastic hammer to pry the slide upward and break the slide free. The carb

put these back when you install the new housing. Removing the cables is tricky, take your time and study how the end-piece slides into the openings of the tube. Turning the throttle one way or another