how many types of gears ? Shift fork, dog gear, reciever gear, slider gear and some bike have sync gears it is a cvt. there is a belt, no gears (like a scooter)
Question about Qlink Legacy 250 Motorcycles
QLink Frontrunner where do you change gear oil in rear end Typically most gear drive motorcycles use the same type of system. There will be a small bolt either 8mm or 10mm or a Phillips head . That ...
...Honda XR250 incomplete bike, was told by owner that it may have the wrong clutch because the small gear on the back of the clutch basket does not mesh with the idle gear between the kickstart and ...
slippage in second gear,pulls fine in all other gears and shifts fine,feels like broken tooth off gear or something of that nature A broken gear tooth will cause a clicking sound. Start out in 2nd ...
Question about Qlink Legacy 250 Motorcycles
what is the gear ratios on a 1990 heritage soft tail 5 speed Here are the stock gear ratios: Gear Ratio (1): 10.11 Gear Ratio (2): 6.96 Gear Ratio (3): 4.95 Gear Ratio (4): 3.86 Gear Ratio (5): 3.15 I
Question about Qlink Legacy 250 Motorcycles
engaging 1st gear the gear grinds an clunks into fjr 1300 yamaha when engaging 1st gear the gear grinds an clunks into gear is my clutch on its way out? Often the transmission will clunk when first ...
Question about Qlink Legacy 250 Motorcycles
I have a 1984 honda vf1000 motorcycle and 2nd gear is going do I have to replace all the gears or just 2nd gear Replace gears in sets, the bad gear and the gear it meshes with. In what way is 2nd gear
When i stick my bike into forst gear, the clutch judders and vibrates like the gears are grinding together, ive taken the clutch off, replaced tge clutch and all it does is make loads of noise and no ...
Question about Qlink Legacy 250 Motorcycles
unable to change down gear. gear lever stays down i have a kawasaki z1000 on an 03 plate. it wont let me change down gear. sometimes lets me change down a couple then the gear lever stays down so i ...
Question about Qlink Legacy 250 Motorcycles
got a 02' 125 ttr and it make a knocking noise in first gear? shifts fine and no other noise in other gears. You have a broken tooth on the first gear set. This means two gears will need replaced; the
63 questions posted
Usually answered in minutes!
14 Questions
10 Questions
1 Questions
0 Questions