1985 Moto Guzzi Le mans III "roll valve float" Questions

...so I have replaced the leads, spark plugs and cleaned the fuel filters etc. If the throttle is rolled on slowly it's not as bad. Get a rebuild kit for your carbs. Make sure u clean the pilot jet ...

...roll over and remove the float bowl. drop the float pin and remove the float and needle. Find the vacuum line to the fuel valve and **** it open to flush out the needle and seat. When the fuel runs ...

roll off the throttle ,have your carbs checked & or synchronized Clean carbs but start with needle valves and ensure seating properly with no dirt, gum or varnish which may prevent proper shutdown

roll on the throttle it coughs through the carb. My Indy shop said it needed a re jet. Had carbs cleaned plugs replaced and reject. It still coughs through the carb! may need to clean or rebuild carb-

...roll startin it but get nothing at all there is no responce the last time i rode it it went fine but became sluggish on throttle responce any ideas??? cheers If you remove the spark plug, attach the ...

...valve at the bottom of it. Disconnect the fuel line from there and check for fuel flow. If fuel is reaching the carbs, then ur floats may be sticking. have you removed your carbs? I did that once on ...

...float bowl vent. Remove the air cleaner connection at the carburetor so that you can look into the carburetor throat. Open the throttle fully, and check if the throat opens completely. If only part ...