1975 Moto Guzzi 850 T 3 "adjusting clutch" Questions

clutch adjustment what's the length of the cluch pushrod?? whats the problem , not enough adjustment ? did you take the rod out ? normally there is a ball bearing in there b4 the rod is it missing ? ...

i have a broken clutch bearing and icant find the spare how can i replace it with an other make bearing Clutch Lever As the clutch lever is operated over time, it gradually loses its grip on the ...

wiring Have a 1978 850T3 took off fairing found bad connections replaced god wiring done front part of bike turn siginals , lights etc , problem is wahat wires goes where starter, regulator, altenator

...clutch adjusting screw locknut and turn the adjusting screw clockwise until it is lightly seated. 6. Squeeze the clutch lever three times to verify the clutch balls are seated in the ramp release ...

...clutch adjusting screw locknut and turn the adjusting screw clockwise until it is lightly seated. 6. Squeeze the clutch lever three times to verify the clutch balls are seated in the ramp release ...

...clutch adjusting screw counterclockwise until the screw stops. Then turn the clutch adjusting screw clockwise 1/4 turn. Install the lockplate and spring onto the adjuster screw flats. You may have to ...

...Clutch Adjusting Cover Loosen the locknut Turn the adjusting screw in until it is lightly seated - Be careful, the screw will keep turning with enough pressure. Just turn it in lightly until it stops ...

...clutch assy buy a clymers repair manual, Try adjusting first but being an old bike i would say a new clutch would be in order if its a cable type you can adjust it by the clutch casing on the ...

I have a 2002 KTM 520 mxc. The bike started shifting hard as it warmed up. I replaced the clutch plates and springs with a Barnett digger kit. Bike shifts good now, but is slipping at higher RPMs. ...

...clutch adjusting screw 1/2 to 1 full turn. When I do this and then set the handle adjuster as per specs the clutch just slips. Won't engage. If I back out adjuster screw 3 turns it seems to work but ...