Unscrew the Oil Filler Cap 3.Remove the Oil Drain Plug 4.Remove and Replace the Crush Washer 5.Clean the Oil Drain Plug 6.Remove the Oil Filter 7.Remove and Clean Plastic Mesh Filter 8.Lubricate the O
Question about Maico 620 Supermoto Racing Motorcycles
Unscrew the oil drain plug counter clockwise and allow the engine oil to drain until it stops dripping. 5. Screw the oil back in place tight. Fill it up with the oil replacement at the place where the
Question about Maico 620 Supermoto Racing Motorcycles
...unscrew the oil filter from the right side of the motor. 7 Spread an even coat of 10W40 motor oil over the new oil filter's O-ring. Screw the oil filter onto the motor by hand. Use a torque wrench to ...
Question about Maico 620 Supermoto Racing Motorcycles
...back in unscrew filler cap add oil once filled retighten filler plug run for 5 mins recheck oil / unscrew oil filter aply oil to seal on oilfilter and retighten on hand tight hope this helped ...
...unscrew the oil plug located underneith engine and drain into a bucket 3:unscrew the oil filter in the front off the engine near the front wheel 4:get the new oil filter and dab some oil on the black ...
...the oil at I am trying to change the oil but I do not know how what do I do On the right side of the bike you will see a little filler cap just forward of your footpeg just unscrew the cap and
Question about Maico 620 Supermoto Racing Motorcycles
Where is the oil filler cap on a Yamaha XJ900 1998 you should see a black cap on the engine casing, rh side as you look down from the seat. simply unscrew.
...oil thinner unscrew the plug at the bottom let it drain into a bucket and then once drained put the plug back in retighten it and unscrew the filler cap and fill with oil until it reaches 3-4 full on ...
Question about Maico 620 Supermoto Racing Motorcycles
...oil plug unscrew it then drop the oil out into a pan once drained put the plug back in and tighten it also it is recommended you change the oil filter every oil change as dirt in the filter will turn ...
Unscrew the Oil Filler Cap 3.Remove the Oil Drain Plug 4.Remove and Replace the Crush Washer 5.Clean the Oil Drain Plug 6.Remove the Oil Filter 7.Remove and Clean Plastic Mesh Filter 8.Lubricate the O
2 questions posted
Usually answered in minutes!
1 Questions
1 Questions