Question about Kymco People S 200 Motorcycles
...a kymco s200 bug it turns over but doesnt start.i have checked spark at plug.no spark,so i had the coil tested its ok,and changed spark plug.but still no go .any ideas Under the seat you should find ...
...903-375-5881. Call if you like since I type slow. check your fuses as well as connections to your coil check your on off switch for power. use a test light for these tests it has to be electrical ...
Question about Kymco People S 200 Motorcycles
...get to it. I would have this tested with an ohm meter before you remove anything. Pulse generator coil resistance should read 70-130 Ohms. 2. Your battery produces power to start your enegine and ...
how to check for spark, harley springer Ignition Coil Primary Circuit Test Remove the coil. THEN set your ohmmeter scale to RX1 and place ohmmeter leads on the primary coil windings A (front of coil) ...
How do I check the ignition coil The bike will not start I checked for spark and there was none Ignition Coil Primary Circuit Test Remove the coil. THEN set your ohmmeter scale to RX1 and place ...
...models and years, but do not know if it fits yours as I do not know what year you have: Ignition Coil Primary Circuit Test Remove the coil. THEN set your ohmmeter scale to RX1 and place ohmmeter ...
Question about Kymco People S 200 Motorcycles
...will turn over fine but I have no fire at the plugs, installed new plugs, still no fire Ignition Coil Primary Circuit Test Remove the coil. THEN set your ohmmeter scale to RX1 and place ohmmeter ...
...cover, behind the adjustor plate. If the filament is not intact you will have no spark. A defective coil, cam position sensor, or stator will also cause a no spark condition. Ignition Coil Primary ...
Question about Kymco People S 200 Motorcycles
...my 2000 Fat Boy and 20 mins later tried to start it but no fire. Turns over but no spark? Ignition Coil Primary Circuit Test Remove the coil. THEN set your ohmmeter scale to RX1 and place ohmmeter ...
...their will not be if both plugs are out of the cylinder and there is not compression. Ignition Coil Primary Circuit Test Remove the coil. THEN set your ohmmeter scale to RX1 and place ohmmeter ...
47 questions posted
Usually answered in minutes!
0 Questions
1 Questions
0 Questions
0 Questions