...fork tube or slider is bent or damaged it must also be replaced now, replace all other worn or damaged components if and as necessary. To assemble a 2007 DYNA fork FIRST insert the seat pipe assembly ...
Question about Kymco Stryker 125 Motorcycles
...fork slider to prevent the fork from dropping, remove the fork cap bolt from the fork tube plug and slide the fork tube down and out of the upper fork bracket, the fork stop, the lower fork bracket, ...
...fork slider (not the fork tube) into the fork tube holder, install the drain plug at the bottom of the fork slider, if it had been removed and tighten the plug to 72-96 in-lbs (8-11 Nm). MODEL FORK ...
Question about Kymco Stryker 125 Motorcycles
...slider off fork tube. Take slider to bench and remove internal snap ring and carefully pry the old seals out without damaging anything. Grease the new seals and carefully tap seal into slider evenly. ...
Question about Kymco Stryker 125 Motorcycles
...fork slider. fill through the top of the forks. be careful the inner springs of the fork tube are under compression when you remove and replace the fork top nuts. installing the fork nuts will take ...
Question about Harley Davidson Motorcycles
fork fluid level on original slider fluid measured 1.5 inches from top of tube manual state should be 4.3 inches witch is right If I put the fluid level to 1.5 will I damage anything was that with the
Question about Kymco Stryker 125 Motorcycles
...slider by removing the fork tube plug and removing the spring. To get to this plug, you'll probably have to remove the windshield, the nachelle, and the top cap. Then loosen the clamp bolt in the ...
Question about Kymco Stryker 125 Motorcycles
...fork tube. Remove the screw and remove the lower slider. It is quite a bit messier as all the oil is not out of the slider when you take it off. When you reassemble, make sure you use the proper ...
...You need to turn the fork tube upside down and find the socket head bolt in the hole where the axle goes through the slider. Take the bolt out and the upper fork tube will come out of the slider. ...
...It sounds like the bike has some serious transmission problems. The bike probably has bent shift forks and a few busted gear teeth and possibly broken dogs on a slider gear. The bloke ripped you ...
42 questions posted
Usually answered in minutes!
16 Questions
7 Questions
6 Questions
2 Questions