2000 KTM SX 250 "rear brake" Questions

...rear bakes 2003 the best way to bleed them is with a syringe and a bit of rubber tube. take off the resavoir tops, crack the nipples. do one at a time. fit tube over the nipple, fit the syringe into ...

how do i install my new rear brake pads on my 2000 ktm 250sx Take it to a shop. If you have to ask, you dont need to be working on it.

rear brake light will not work when brake pedal is applied, both front and rear brakes run through same sensor front brake applies rear light, but rear brake pedal doesnt. where is the problem? It ...

...rear brake pedal operates the rear caliper and the front disc. When you tried to bleed the left front caliper you let air into the rear brake system. Bleed the rear brake and front left caliper using ...

...rear brake master cylinder. Something is wrong with this as your rear brake is not working. The brake light for the rear brake is activated by a pressure switch whereas your front brake light is ...

...rear brake pedal to control the rear brake and the front is controlled by a brake lever which supplies 3/4 of all stopping power. Dont ever slam down on the rear brake pedal just apply it gradually. ...

rear brake light pressure switch. Follow the metal tube that comes out of the rear brake master cylinder going back to the rear brake. You will find a pressure switch in the line. Disconnect the wires

rear brake light not working The brake light is turned on and off by either of two switches on your bike. The front brake lever has a switch located in the right handlebar switch housing. When you ...

...rear brake caliper about a half turn. Press the rear brake slowly until it stops and hold it there. Tighten the rear brake bleeder valve while holding the rear brake pedal down. Then, release the ...

...rear brake switch on a 1972 harley ironhead sporster? Been a long time since I've worked on one of those but the '72 model Sporty has mechanical brakes on the rear. There is a rod that runs from the ...