Question about Buell M2 Cyclone Motorcycles
...motorcycle Take cover off where u adjust clutch on primary just follow clutch cable where it enters primary to right 4 bolts get new gasket from harley take off cover below is a drain bolt take out ...
...clutch spring plate reduced effort clutch spring on a 2003 FLSTIC [email protected] I've never really torqued these bolts and I've replaced plenty of the diaphragm springs. Usually I put stronger ...
Question about Buell M2 Cyclone Motorcycles
...torque specs for clutch relese springs 84 gpz 1100 I just put anew clutch/ drive hub& release springs in my 84 gpz . when i tighten the springs to specs , and try to pull in the lever the clutch ...
Question about Buell M2 Cyclone Motorcycles
clutch spring bolts for a 2006 crf450r The clutch inner hub torque values ar 7.5Nm or 7.5n-kg or 54 ft-lb. The clutch springs torque to 8Nm or 0.8m-kg or 5.8 ft-lb. I don't get paid for my answers and
Question about Buell M2 Cyclone Motorcycles
...clutch.spring bolts undone,springs come out,pressure plate then will pull off and the plates will slide off and thats it but what you will require is a torque wrench to torque the clutch spring bolts ...
Question about Buell M2 Cyclone Motorcycles
clutch springs torque spec whats the torque specs on yzfr125 clutch springs @ The bolts should bottom out and reach about 22NM,,, about 15 ft.lb. I always used a dab of blue Loctite.on clean bolts and
Question about Buell M2 Cyclone Motorcycles
clutch plate spring bolts What to set the torqu on clutch plate spring bolts thanks to who ever can help Hi Charles, Try the following sites: http://suzukiclub.co.uk/tech-specs Homepage venold com The
...if the clutch has 4-6 springs as most do. The bolts that hold the clutch springs in tighten all the way down until they are snug (I would say about 100 inch-lbs max for each bolt
30 questions posted
Usually answered in minutes!
43 Questions
13 Questions