ball peen hammer try and secure the carb so it wont be damaged and take the punch mak sure the tip is sharp enough on the outside edge of the head of the screw make indentation and hit it in the
head bearings arn't too loose. Also kheck that your engine mounting bolts arn't loose. Hope this helps regards Andrew Porrelli Thanx for the advice. But i think i have done everything you described. I
...on the bottom of the case and one with an allen head close by. i undid the allen head but it had a spring and a ball inside new to me? my first ktm hi buddy the one with the bolts is the drain ...
head bearings. Double check that all your motor mount bolts are tight. The steering neck bearings on these bikes routunely go bad. They a cheap ball bearings like you would find on a bycycle. There is
...Head lights do not come on when motor starts. High beam indicator is on and can not be turned off. Front indicator lights are also on. Sounds like you have the bad bulb, but if you can get a meter on ...
Question about Bajaj Pulsar 180 Motorcycles
2003 suzuki vl 800 volusia front end very hard just got the bike very ******* turns when i turn it is shaking a little but tire is all so balled Steering head bearings replace them and the tires.
...head bearings are not tight, and you are running too low of a pressure in your front tire. The neck bearings in these bikes are junk. Check for replacement with a brand called "All Balls", they are a ...
43 questions posted
Usually answered in minutes!
81 Questions
90 Questions
12 Questions