2005 Bajaj Pulsar 150 "straighten forks" Questions

how to adjust light beem of bajaj 220 the beam can not br adjusted alltogether the fairig holder that is connected to the fork might have bent try removing it straightening it

...fit. Depending how badly they are bent, it may be straightened. By using a press it is possible to straighten the forks if they are not too badly bent. I have done this in the past... It's not

get one of the fork tube out and go to machine shop they can use a hydrolic press to straighten it.And there you go!!Forks is back on..Please note you have to align the forks by twisting the steering.

...forks on current models, is thin and they distort if you try to straighten them, if you measure at the bend they are not likely to be round. there may even be stresses and fractures that would need ...

straighten the front forks up if I loosen the nut on the headstock, move the fork legs, and retighten the nut again? the bike is a VL800 k5. Loosen the front fender, the axle retaining bolts, plus the

straighten bent fork tubes without use of a hydraulic press. Once your front fork tube clamps are back in alignment, check each of your forks before you re-install them to make sure that they aren'

I have a 96 night hawk 250 and the previous owner ran into the back of the garage. the right fork is slightly bent. Is there anyway to fix this without replacement hi. some places do offer frame and ...

...it. Some shops can straighten forks but triple clamps also can be straightened but you will have to look for a motorcycle frame shop for that service. other than that replacement is the other ...

by pouring the required amount into the upright tubes make sure that the levels are the same, use a straightened wire coat hanger and measure the level in each fork so that any differences are reduced

...with the front wheel off of the ground. Your forks may have twisted, and all needs to be loosened, straightened, and re-torqued. Note...you can destroy forks if you don't properly torque tripple ...