Intermatic & Indoor/Outdoor Rain Tight Timer  "lights not off" Questions

...on it will not shut off. If I then use dial to turn off light will not come on at set time. reset timer and reprogram or buy new timer http://waterheatertimer.org/How-to-troubleshoot-timers.html ...

not know how to set the timer. It is hard wired in the garage and set to operate outside lighting. I am looking for help to set the timer for the lights to come on at dusk and go off at dawn. Here are

...lights will not turn off until dawn. You can test timer by putting black tape over photo eye, and then timer will turn on. Set timer for 2 hours for example and then check if timer turned off 2 hours ...

...not turn lights OFF, then plug power pack into cheap wall timer. http://waterheatertimer.org/Malibu-power-pack-stopped-working.html Link above has trippers, troubleshoot, installation tips, and ...

not grounded properly. This can cause issues with LED lights since they are basically diodes and can "leak" power in reverse bias. Most of these timers have a three-prong plug - they should be plugged

...lights will not turn off until much later than planned, or not turn off until dusk. You can test timer by putting black tape over photo eye, and then timer will turn on. Set timer for 2 hours for ...

...NOT accidentally PRESS at the same time. 4. Press pushbutton time dial once to enter present time. • red indicator light goes off (present time has been recorded). 5. Turn pushbutton time dial ...

lights or car headlights. 4. Now turn "ON" the power to the lamp. Unit is programmed by simply pressing the Timer button. The first push of this button will cause the light to flash 1 time and set the

...not disconnect ground wire unless power is off. Turn power back on. If lights are off, then the wire going to light is bad, or a light fixture is bad. Caution. If there is a short, do NOT touch light ...

...lights, but that did not work either. Any idea what might be wrong? Thank you, Lisa Did this ever work before, or is this a new installation? Assuming this is a new installation, it's 90% likely to ...