Samsung RS2630SH Side by Side Refrigerator "tray keeps opening closing" Questions

...holes are not blocked - the problem is that the water does not evaporate away, it just fills the tray then after about 2 weeks from empty, pours over the floor. The tray is as close to the ...

...KEEPS FLAPPING OPEN AND CLOSED. i REALIZE THAT THE PROBLEM IS COMMON AND SHOULD BE FIXED BY MAYTAG. hOWEVER IS IT STILL GOING TO KEEP EVERYTHING COLD? Budd, if you want to stop the flapping until ...

...opening, the rubber fill tube, which fills the ice maker tray, had frozen up inside the tube. I had already replaced the ice maker, and still no ice. I am sure a repair person will shudder, but I ...

...the water comes into the freezer part of the ice maker it keeps running .dose not shut off once the trays are full. Really sound to me that the water control valve is defective and will not close. ...

...is on the cube selection it delivers crushed ice sn a very little water. I removed the ice holder tray and looked up underneath saw that the little flap was closed so the cubes could not fall. I ...

...keeps filling up with water. Door fits and seems to seal well.(after closing, takes about 10-20 seconds to pull open again) Been a bit hot and humid here lately (So. Cal). But nothing top severe. I ...

...of the freezer.. We now think the water (ice) was a separate issue - someone didn't put the ice tray back correctly? look down at the bottom crisper and there should be an air control that lets ...

where is the reset button on a french door lg refrigerator the icemaker quit working. The ice tray is inverted and twisted like it stopped after dumping the last tray of ice. Keep reading ...

...behind the freezer compartment then clean the evoporator drain ways and pipes then dress the flow trays and tubes with salt add salt too the evaporator tray check the thermal fuse on any heating ...

...tray and the water keeps running into the freezer and all over the floor. The fill solenoid is being opened but does not close properly- the solenoid could be getting stuck in the open position. If ...