Samsung RS2630SH Side by Side Refrigerator "temperature flashes hi" Questions

...temperature indicators flash after a few hours of the unit being switched on? Hi, some fridge freezers the indicators flash as they have not got to the right temperature yet. Also some freezers have ...

...HI temperature. If you are still receiving the alarm, I suggest checking the freezer, to make sure that everything is still frozen, and nothing is defrosting as, well as checking the refrigerator ...

...temperature degrees number. You vary it, hi or low and the unit still cold or freezing. Sometimes the liquid crystal display of the electronic control module become loosen 'cause it to display in ...

...HI temperature. If you are still receiving the alarm, I suggest checking the freezer, to make sure that everything is still frozen, and nothing is defrosting as, well as checking the refrigerator ...

...temperature went up to 47 degrees, but has no flash. What is goin on? HI this is a difficult one without a visual but i would sugest u disconnect the power supply.re-connect everything again and ...

...flashes on and off. According to the manual that indicates the temperature is above 12 C and may be due to a fault. Over the past couple of days, the fridge won't chill at all. We also have the ...

...Hi I was just changing the temperature setting on the refridgerator. Then afterwards the warning light starting flashing and there was a loud beep. I pressed the warning? light (the light on the far ...

...Hi the following should tell you all the info about the controller Directions for Accessing and Setting G3 Series Digital Controllers Changing the Temperature Instructions for changing the desired ...

HI 66 the control board has a high temperature alarm which in this case it exceeded it and is telling you so. At this point I would say keep an eye on it, should you continue to have any problems then

...flashes. At the temperature display a bar is lit up and the temperature of the freezer can't go lower than - 10 C. I have clean the ventilation gaps. What should I do? Thanks in advance for your ...