Question about Kyocera FS Office Equipment & Supplies
...Drum motor error DMOTRDYN signal does not go low within 2 s after DMOTONN signal goes low. The cause is; Defective harness between drum motor and engine PWB (YC11), or improper connector insertion. ...
Question about Kyocera FS Office Equipment & Supplies
again. Otherwise the problem could be a bad signal coming from one of the circuit boards, or it could be a bad drum unit. You could try replacing the drum unit, but that may or may not fix the problem
Question about Kyocera FS Office Equipment & Supplies
...5300 on kyocera 9130 printer Broken cleaning lamp wire While the cleaning lamp is on, the broken cleaning lamp wire detection signal is detected for 2 s continuously. Id look at replacing the drum ...
...signal error) but we see this being the power supply and/or bad power to the unit. Check your power outlet (it should be on a separate or dedicated plug with no other devices). Remove and re-seat the ...
...signal error)but we see this being the power supply and/or bad power to the unit. Check your power outlet (it should be on a separate or dedicated plug with no other devices). Remove and re-seat the ...
signal cycle is not as indicated (±2%). During the WMUPR period after the power switch has been turned on or the front cover/left cover has been opened/closed, the drum unit is absent. Possible cause:
...drum end soon" signal on for about one month You will need to replace the Drum unit with a new one. To try to get it working for a short temporary fix, clean the Drum corona wire - might work, might ...
...Drum/ development bias output error An error signal is detected for 0.2 seconds when charging the drum or development. High voltage leak Broken harness Defective drum unit or development unit ...
Question about Toshiba Office Equipment & Supplies
...the imaging drum before a jam signal is issued. Did you get the drum shaft reinstalled and latched? If not, the drum won't rotate correctly which will cause poor transfer (smudged image) and
riso rp error t98-526 526 Drum set safety switch is ON, but drum connection signal is OFF. try to remove the drum and re-install it. hope to be of help
166 questions posted
Usually answered in minutes!
192 Questions
143 Questions
97 Questions
55 Questions
66 Questions