Weiser Lock POWERBOLT ELEC DEADBOLT "opening door 2" Questions

...but cannot find manual to figure out how to reprogram remote. Older model (15+yrs old) Model: SEARS/Craftsman 1/2 HP garage door opener push the green button on the opener then push your remote ...

door. 2 Locate and remove the battery cover on the inside of the door. 3 Replace the used batteries with new ones. For most safes, this will require two or four AA batteries. 4 Test the batteries. Use

kwikset keyless entry is backwards the lock button opens the door and the code locks the door The config terminal is wrong. Take the cover off and move the 2 pin terminal over one pin.

...door (hinge side) press this , then key in a new code There is a small hole in the back of the safe. You can go in through there and push a button . Hold the button till the light comes on and ...

Enter your 4-8 digit code. Push the lock button to end the entry. As before, the unit will emit a 2-second long beep when a successful entry is made. Test your codes with the door open just to be sure

...Door Direction Jumper". If the cap is mounted on Prongs 1 & 2, carefully remove it and move it over so that it mounts Prongs 2 & 3. A is right handed, B is left handed. This link will ...

...door jamb/strike plate. Also, these locks can be internally adjusted for installation in doors with a 2 3/8" or 2 3/4" backset. Is it off by about 3/8"? if so, check that.Some months ago I suggested ...

...door whose hinges are at the right or left as you face it. ( right-hand or left-hand opening).You may need to move the jumper from across pins 1 & 2 to across pins 2 & 3 or vice versa because ...

...opening. I have installed your Powerbolt, but when I push the Lock Button, it unlocks? What should I do? First remove the cover on the inside of the Powerbolt unit. On the right hand side under the ...