Hitachi NR83AA3 3 1/4" Clipped Head Framing Nailer "oil put air compressor" Questions

put single drop of oil into air intake every hour or two - depending on workload, i use oiler. but sometime when this is not feasible, i just put drop or two of oil into air intake on the beginning of

...put a great deal of lubricate in the gun prior to using. Excess oil will eventually be consumed /blown out of gun, however if you store the gun over-nite with air inlet pointed down, gravity will ...

...firing they will do this after about six or seven shots. Once the compressor catches up they work fine again. Also make sure you put six or eight drops of gun oil in the air inlet each

put oil anywhere else because it will attract dirt. You should also do the same if the gun is not used for awhile and fire it to cycle the oil into the o rings. Just as an addition to the other chap's

Put a couple of drops of a light oil in the nailer with the trigger depressed, and the gun disconnected from the hose. Set it to the side for now, with the air inlet facing up. 2. Check the compressor

...put gun together, do not forget to lightly oil all assembly surfaces with compressor oil. This is very good gun and should serve you for many years to come, we use these for last about 8 years rather ...

oil. I put one drop of oil in the slot where the brads come out [realizing that is where the driver is located] and left the gun upright for some time. The next time I used the gun it worked just fine

...WILL NOT DISCHARGE AIR,TO LET DRIVER COME IN FRAMPRO602 Disasemble and clean the unit. check seals. re assemble and check function. try putting some compressor oil in the nailer, probably just