Question about Stanley Air Tools & Compressors
...NAIL INSIDE THE GUN you have a problem with the nose or the driver. I would also check for a jammed nail in the nose assembly. let me know what the model number is and I will try and find a breakdown ...
Question about Air Tools & Compressors
...nail in gun or the driver blade tip is no longer square. Easy to check both. With nails removed strike nose of gun down against rubber mat or soft wood to move driver down for examination. It should ...
Question about Stanley Air Tools & Compressors
gun will fire staples, but when you go to fire a nail or brad it will not set the nail, it bends the end of the nail. Shoots staples fine but brads jam or bend. Check that the part called "guide bar",
nail jammed in the gun.The temp is about 20 degrees.We are in Wasilla Alaska. What should I do? Thanks Wayne does the nose piece go back as far when you actually use the gun as when you pulled it back
Question about Air Tools & Compressors
...nail bending it and jamming the gun. It was working then this started. The gun hasn't been used that much. I have tried different string of nails and they are Bostitch nails. There are many brands of ...
Question about Air Tools & Compressors
nail over One problem may be your air pressure at the gun. It should be between 90 and 100 psi to fully drive the nail fast enough to prevent nails being left high in the work or bent over.
Question about Air Tools & Compressors
...gun driver goes down and stays down and will not go up I put it up and it will shoot nails and a few nails later driver stays down i bought it site unseen they said it just blowed air,i put a rn46-rk ...
Question about Stanley Air Tools & Compressors
...nail and jaming the gun odd, but may be nose part loose and or the magazine too loose, is your driver bent? the magazine and the nose part meet check under the cover and make sure all the 3mm hex ...
...your gun (measure the angle with a protractor) . The lumber yards do not have a very good selection of brands. Try a professional fastener store that deals in nails and nail gun repair. Good ...
Question about Porter Cable Air Tools & Compressors
...replace head and connect to air however lower pressure to 40-50 psi and nail into soft wood increassing the pressure little at a time with each test untill full pressure around 90-100psi. Good ...
81 questions posted
Usually answered in minutes!
39 Questions