...tiller. Grinding noise from gear box while moving - under power or not. This machine has a fairly simple chain drive to the wheel axle shaft, there is a sprocket on the shaft itself, this may have ...
...Tiller was working well. Left it for a couple days then went to start it and it pulls easily and fires and runs for few seconds and then dies. If you pump the primer it will start again but die after ...
...tiller that I would like some information on, but was not able to find anything about this machine. could you plz help me locate anything . It is very old but seems to want to start but want to get ...
...key and it appaers not to be sheared. (Have not actually pulled the flywheel yet) Machine is a 5.5hp tiller with techumshe engine Sounds like drity/bad gas to me. Do a system flush. Check
tiller with a 5.5hp b/s engine. its able to start time and time again w/ full choke and throttle but dies out You need to rebuild the carborateur, it sounds like the diaphragm has played out, when you
...tiller will start but will not idle or continue to run. It should NOT be touching or scraping. There should be an "air-gap" of approximately .010" between them. This is about the thickness of a ...
...tiller. Should it go toward the engine,or back toward the handle. it is normal to have small graphic items at each end of the lever. Tortoise and a Hare. To start from cold, move the the lever fully ...
...machine not even a year old. Not Happy. I do own a Troy Bilt tiller also a Troy Bilt mower. Cecil, I am curious why this repair was not covered under the warranty? This snow blower has a 2 year ...
...tiller "like new" (refurbished) from Lowes in Sept 2011. I have not used it since then but took it out to prep it for this fall and it will not start. I have followed all prep instructions ...
308 questions posted
Usually answered in minutes!
1,998 Questions
1,006 Questions
710 Questions
725 Questions
285 Questions