Craftsman 26 hp 54 in. Deck Deluxe Yard Tractor - CA Model "install 2 mower" Questions

...2 Lawn Mower. I've purchased a new battery and cannot recall the re-install sequence. I think I have the the batteries installed and wired in series to each other correctly. I just cannot be sure of ...

a Craftsman riding lawn mower, 17.5 HP? the mower won't start, starter components broke It mounted to panel under the dash. Unhooked battery, (2)then unbolt solenoid,(1)then unhook wiring. Install new

2 years old but its already had to have another drive belt installed by the dealer last year. wanted to do it myself but when i install belt theres hardly any tension so mower doesnt move. Checked and

2 sharpen,1ata time,installed them, probably not in exactly the same position.started mowing the mower mows about a foot then stops mowing i back up, it starts mowing again so i go forward about afoot

...2 year old Husqvarna riding mower, with the welded steel deck, has the mulch kit installed ( I installed it). When cutting, the mower ususally leaves a thin line of uncut grass. More, when the grass ...

...It's best if the engine is warm. You should get 1 1/2 quarts of oil out of it. Let it drain for about 5 minutes and then re-install the pipe plug. Add 1 1/2 quarts of 30W oil and then cut the grass

for approx. 2 years, have drained gas, have installed new fuel filter, but mower will not run except when carburetor is primed. Need to remove carburetor and clean out jets install new kit and replace

...mower, car fan belts are not the same material (2) was new belt installed to tight to begin with if so it will stretch out and slip ( 3) is mover over used to it's designed purpose , I once new a guy ...

...the 2 last step is the square metal washer then the nut. to install the metal washer the match the shaft guide. if still can't tighten the nut then the problem is the armature ring may drop

...can't get it on. Any ideas that might help? you have to raise the mower then drop the rear of the deck by removing the 2 pins on the blade adjustment lever.once you do that it should go pretty ...