Ryobi 18-inch Electric Chainsaw Chain Saws "motor running turning" Questions

...motor should stay running.... if not adjust the screws until it stays running. Turn one screw in until you hear the motor start to stall, then turn that screw out just a little bit. turn the other ...

...have gone bad. Does the motor 'hum' when turned on? A start capacitor could have failed in that case. Contact the selling dealer for warranty help if you can't get it running again. Hope this

...run after pulling most of plant from inner part of chain. Makes humming noise The humming is the motor trying to turn. Remove the drive end cover from the bar and chain--back off the chain ...

...carb) The instructions for adjusting carbs, years ago, on 2-stroke, say to back out on the L when motor will not rapidly rev up. Most 2-stroke carbs have these 2-jets. The L is for gas to pass to ...

...motor just sits and hums without turning. If this is a three-phase motor, the overload button should shut off the motor starter which directly removes power to the motor. Don't jury-rig a switch to ...

wild thing motor runs but sproket doesn't turn brand new used for about 15 minutes motor runs fine but the sproket doesn't turn removed the chain and bar also Hi, The clutch is shot! This is right at ...

...motor was running and than I seen alittle bit of smoke by the little box on the top of the motor. and it stopped? It would hum but would not turn, but I could turn it by hand easy enough. This is an ...

...once, then stopped again. When you look under cover when motor running, chain gear not rotating. Is there a gear- box problem? yes the gears can strip look at sears parts online for a break

running straight gas, not mixed. And, even if motor frees up, it may still need to go in for repair. We have a couple of Poulin Pros at this saw mill where I work, and have had the piston lock up more

...it run for a few minutes. Adjust the low speed circuit at idle until it runs smoothly, then rev the motor to full throttle and slowly turn the screw out until it starts to run a little rough, then ...