Husqvarna Chain Saw 20" Bar "chainsaw kill switch" Questions

where does the kill switch wires go Coil too the kill switch , kill switch too the ground good clean metal.. Kill switch is just making the ground conection.. Goodluck..

...chainsaw and the kill switch wire was disconnected. Does it need to be in order to run? The on/off switch must be connected and switched to ON to run. The kill switch if it is the type of switch that ...

chainsaw stopped working (didn't kill the running engine). Tired of pulling the choke, I replaced the switch, and in the process noticed a break in the two strand wiring harness. I replaced the wiring

...chainsaw that starts and runs just fine. However, the stop switch doesnt seem to work. I push the switch to stop and the saw continues to run. The only way to kill it is to use the choke. Is the kill ...

...chainsaw because I thought the old one was shorted to ground. The new one reads the same way. Doesn't the kill switch wire short the coil to ground to turn it off? And shouldn't the connector on the ...

chainsaw runs fine than goes full throttle all by its self and cannot shut it off with switch. Kill switch is broken or disconnected. Throttle linkage is broken or disconnected or idle is set way too ...

...saw will not spark Spark plug new, HT lead ok, kill switch ok, kill swich lead ok, all moving parts cleaned. still no spark?. kill switch wire short to earth on casing or coil open circuit Re: ...

...kill switch on a husky 288 xp There should be only 1 screw and one wire connecting the kill switch. The kill switch simply grounds out the ignition. So it is difficult to install improperly. The wire ...

...chainsaw will not shut off. I replaced the kill switch and that did not work. The wire and connections look fine. I assume the ignition coil is ok since it starts fine. Anyone know what it could be? ...

...chainsaw aND NEED TO KNOW WHERE TO CONNECT THE KILL SWITCH WIRE THAT COMES FROM THE IGNITION MODULE generally the wire goes to the kill switch which in turn is screwed down to the body of the saw ...