...pulls easy when spark plug out. Could it have something to do with muffler? quick check would be to pull muffler from engine check the screen if the screen is ok start engine if it starts without the ...
...pulls OK. I have a Homelite XL and was having problems with rope pulling from difficult to unable to pull rope while trying to start saw. I removed the muffler, squirted some WD40 through the exhaust ...
...ok, open the throttle and pull through several times to expel excess fuel from the cylinder. Check for blue snappy spark at the plug after this--if weak or nothing, try a fresh plug gapped at 0.020". ...
...without choke being pulled out 1/4 . it will start,run about 2 seconds and die,i can pull the choke out about 1/4 and it will run ,acts like its starving for gas.the tank is full of good gas.is there ...
...ok, switch on ,chock out ,will not start. I suspect your ignition module is bad try this. Ignition Coil Test ...
...Without starting fluid sprayed onto the air filter, saw won't even pop or burp when pulling starter. Once started, it will run ok until I 'bear down' into the wood, then it ...
chainsaw is locked up Pull rope is OK. Pull the plug; maybe it will turn; I think piston melted to the cylinder. From your question start with 3. Starter Handle difficult to pull: 1. Remove the ...
chainsaw for about 2 years. In those two years it?s done everything I?ve asked of it including starting very easily every time. I?ve been extremely happy with it. I cut some wood on Saturday without a
...chainsaw. I can get it to start and stay running as long as I have the choke on. I can even run it at high speed using the choke control. When I pull the trigger to feed it gas it starts to stall. I ...
chainsaw a break by turning everything off. Flip off the on/off switch. Turn the throttle off. Push or pull the choke to the off position and deal with anything else that might need to be switched off
513 questions posted
Usually answered in minutes!
583 Questions
255 Questions
170 Questions