Poulan Pro Chain Saw 46cc 20" "chainsaw dies pulling" Questions

Chainsaw will start and idle if choke is pulled out, but when choke is pushed in or trigger is pulled to saw (thus deactivating the choke) the chainsaw dies. Let it warm up first ...

...chainsaw starts up it will idle the min. you disengauge the high idle on the choke it runs for about 3 seconds and then dies like it ran out of gas When it dies pull out the spark plug. If it is dry ...

poulan blackhawk 1635 , it starts fine , but when i pull the trigger it dies it start fine , then i pull the gas switch it dies on me ? Running to lean, replace the fuel filter in the tank, turn the H

...chainsaw warms up it dies unless I pull on the trigger. How do I adjust the idle I just don't know what screw on the carb orator to adjust and which direction The T is the 'tick over' ...

chainsaw. Starts OK but Flutters then dies after 3-5 minutes use. Wil not restart. First thing check fuel and air filters.Also pull the plug out to see if there are any scratches in the cylinder.If so

My chainsaw starts and idles fine but when I pull trigger to a point that butterfly opens it bogs down and almost dies. Has fresh fuel Fresh air filter?

...dies or even when I let off the throttle to idle it will die. Is this fuel line o dos the carb. need to be cleaned? How do I access these parts if so. New to fixing a chainsaw.Thanks! It sounds very ...

chainsaw. It has a choke pulled out all the way to start it then runs/revs to high. when he pushes the choke in it dies. what needs to be fixed inside? check ur governor spring or linkage---adjust air

chainsaw wont throttle up dies out;cleaned out carb. relaced fuel lines . give it gas wont throttle up.adjusted high and low speed screws no luck. replaced fuel lines and filters.sounds like its ...

...chainsaw, will cut wood with out pulling trigger. Runs is very vast, dies when pull trigger. I would say it has an air leak, through a gasket or crank seal, make sure the carb is tight and sealing ...