welder swith seams to be broken Buy a 220V/50amp standard switch and replace it. Any home depot has it.
Hobart welder 135 machine is still on like it's on when the switch is off Replace the switch.
Question about Welding Tools
Looking for a Manual for a Wards Powr-Kraft Arc Welder 200 Amp Model # 110-107 I'm needing to replace my On/Off power Switch. it should be a straight forward swap with a power switch just 4 ...
...replace the heat switch find the round circular disk with 2 wires and white grease buried in the main transformer. should be on the outside of the coil r&r the thermal cut out switch. the heat ...
your machine (welder) that solenoid valve must got dirt or debri from the hose and the closing needle it's stuck . Just replace it, it will be cheaper than replacing your gun.Have a great day
...welder is switched off for 5 minutes...i would have thought an overheating but nothing feels warm...the fan dies out badly while welding It may be the bearings are gumming up. Try oiling with ...
...welder will overheat as the cooling is designed for average use. I am thinking that your temperature switch is not weak but operating as normal. I would suggest therefore increasing the cooling ...
Question about Clarke Power Products Welding Tools
...JUST far enough to gain access to the switch,check for and correct :corrosion,rust,oil or grease buildup,and/or damaged contact(s) at that station. That doesn't work,replace the switching
...for a very short time and I heard a slight pop from the welder . now no welding . checked ground, replaced tip ,tightened thumb screw on cable, fan runs ,wire feeds , no weld. check main contactor ...
...by disconnecting the gun cable (not the lead) and using a paper clip to by-pass the gun?. If the motor turns then you need to replace the gun switch if not probably the PC board fuse it's
47 questions posted
Usually answered in minutes!
70 Questions
28 Questions
