Hobart Handler 140 Mig Welder "wire whip" Questions

wire drive is the liner of the whip. Where this is clamped to the drive is the connection, inspect it. then the electricity travels down the liner to the contact tip, which is how the electricity gets

wire will not feed out hangs up in hose then replace the hose . it might be wore thru inside . Depends on the machine. On many MIG welders you can replace just the liner of the welding lead (or whip).

...whip to the gun.any suggestions that I may try to trouble shoot problem? There is an inline fuse with the power feed to the gun, it may be blown.  It is usually under the panel that exposes your ...

...whip and see two prongs that are sticking out to allow the 2 wires to slip onto the conection. It should not matter which wire goes on which tab but both have to be connected. After that then turn on ...

...is over 5 years old and i dont have manual to get part numbers off of . can switch be rebuilt or do i have to purchase new wire feed whip ? sounds like you lost a spring i would just get a new ...

whip and it doesnt feed wire or strike an arc Sounds to me like the Power Controller has gone bad. These are a real tricky, dangerous, things to fix yourself, I recommend that you call the service rep

...wire immediatle sticks inside the whip. I tried a bigger brass tip with the whole in it but still the same problem. I am also using the anti splatter paste. The wire seems to stick inside the coil in ...

...Also checked our argon supply gas and mixing valves, which are all fine. Try to turn up the wire feed and the volts and pull the cup 1/8 inch past the ...

WIRE STOP FLOWS AND ACCUMULATE AT THE INTERANCE You need to remove to whip and blow it out. Metal dust builds up in there and it gets in a bind. Also, check the inner coax to be sure it isnt bent. You