...drive wheel being too tight be a possible problem? you can either turn amps down or turn wire speed up,make sure drive wheels are set for the size of wire you are using,one side is set for example ...
...drive rollers, and push the wire into the gun by hand. you'll feel if there are any tight spots ( usually caused by kinks in the liner). once you've rigged it, clamp the drive rollers ...
...drive motor collect a lot of metal dust from the environment and it requires a clean up. Take the tensor off and remove all wire, try to apply compressed air into it and then apply WD40 and run it. ...
Question about Hobart Welding Tools
...drive wheel tension per instructions in owner's manual. Make sure tip is clean and of the right diameter. I had the trigger switch go bad once. As it deteriorated the operation became erratic. Check ...
146 questions posted
Usually answered in minutes!
26 Questions
20 Questions
13 Questions