...ground. This could be a lug inside a breaker panel, a driven ground, or a water pipe saddle. If you are using the generator outside somewhere and not near a building, a driven ground can be used if ...
...ground....undo the lug that connects to the chassis ground and wirebrush that lug...and the space where it bolts to, think that insufficient ground to the relay box has the relays dropping ...
bought used gen. and the wires were cut to thestart wiring. on the starter there will be a big lug this is where the (+) from the battery goes then there will be a smaller wire lug called a spade lug ...
Question about Electrical Supplies
...ground lug mounted on th I've looked all over the unit for traces of where these three wires could have originated and see absolutely nothing. I've down loaded all of the manuals and wire diagrams I ...
...ground cable going to the frame, you have another cable that runs over the battery compartment + that runs all the way up to the + lug on back of the generator compartment. if you don't have 12v ...
Question about Yamaha Electrical Supplies
...wire term.at the ground lug.will this inhebit the workings of the unit? Unless you are going to use this exclusevly for 240V service, this is a bad idea. Your 120V legs will float between 0V and
Question about Worldwide Electrical Supplies
...lug on the alternator to get that done... and be CAREFUL not to ground that wire! If you can get your meter's probe to the alternator with the engine running, all the better. I'm betting the ...
...ground lug on the bottom of the gen. Another way. if you dont really need 220 v. is to use both 120v. recepticals on gen. Run 2 chords to tranf. switch. and hard wire it in to switch. another way i ...
...instructions. If you use aluminum make sure to place anti-oxidation compound or Nolox on your lugs in the panel. Please write back with anymore
Question about Reliance Electrical Supplies
...and forth it makes noise like the lugs are loose? sounds like lug nuts are loose when you have it sittin on the ground and push the side of the tire Wheel bearings have excessive wear, replace
338 questions posted
Usually answered in minutes!
