I have a porter cable 5500 watt 10hp gen its now running wide open how/what do i adjust to have it run normal?? high idle screw or governer
I have a 1967 Detroit diesel 225 driving an ACDelco 30kv generator. All works great except generator is putting out 50 cycle rather than 60. How do we change? What is the governed speed of the ...
Question about Electrical Supplies
...voltage output readings are governed by rpms of the motor check that the engine rpms are correct by adjusting the governor setting contact hyundai generator service center for ...
my honda 5.5, 2500 w works fine but since a fue months my televion won't work on it everything else does also other electronics like dvd satelite reciever, what could be the problem? It sounds like ...
Question about Electrical Supplies
wenling jennfeng generator governor not working, linkage ok, speed ran away while in use while running generator engine speed increased rpm's really high. has no governor control apparently. trying to
My generator does not throttle up automatically Although I can manually adjust the throttle and thus produce power, my generator used to do it automatically, what needs mending please? Hi there, I've ...
Question about Kohler Electrical Supplies
...fuel and/or gum in carburetor. 3. Faulty spark plugs. 4. Fuel supply inadequate. 5. Idle speed adjusting screw improperly set. 6. Idle fuel adjusting needle improperly set (some models). 7. Low ...
Powermate 6250 loaps. Filled new generator with oil and fresh gas then started engine. The engine loaps with the carb linkage moving back and forth on it's own. I also do not see where engine speed is
Have Onan 3.6 KY propane gen that will not keep running. Runs only as long as start switch is pushed. Then stops immediately after release. Fault code is 15 (underfrequency) and suggests removing ...
18 questions posted
Usually answered in minutes!