Flotec Corrosion Resistant Shallow Well Jet Pump 1/2HP, 8GPM "install submersible" Questions

Ad

so you shouldn't oil the pump, but rather follow the recommendations as to making sure the pump is installed properly. Here's the owners manual for your particular pump (Model #2300) so you can check

Ad

Question about Flotec Plumbing

1 Answer

...install a self-priming pump, sometimes the will not prime or this one is stopped up from dirt. also is it submersed in the water or above water level. if it is submersed and is not meant to be, it's ...

Ad

Question about Flotec Plumbing

1 Answer

NEW PUMP DO I HAVE TO PRIME IT Very few pumps these days need priming the installation instructions should say and if it is a submersible no. I could give more info if I knew witch pump you have.

...submersible pump on the product site: http://www.lowes.com/pd_240035-84862-KLH075_0__?productId=3880627 . Click on the Info & Guides tab. The direct link to the guide is ...

I am installing a hydromatic pump in my cellar . When I turn it on water shoots out of a tiny hole on the side . It seems to be there to prevent air lock . is it supposed to shoot out when pump is ...

Pump will not kick on after pressure drops. Just installed a new pressure switch and pressure tank. Hi Tony1. Check your opening to the pressure tank to make sure it is clear and reading the pressure ...

Question about Little Giant Plumbing

1 Answer

This is the second time I have replaced the pump with no good results. This pump drains a pedicure chair. Some times it will drain sometimes not.Motor runs, with water going to inlet,but no flow ...

Question about Tsurumi Pump Plumbing

2 Answers

turned it off now it will not keep spinning I have a 50PU2.15S and now that i turned it off it will not stay spinning. If i unplug it then turn the srew in the bottom it runs normally for about 30sec.

Have installed a new 1/2 hp jet pump for shallow well. Everything is new including the WellMate Tank WM6. I prime the pump, turn on the power and the most psi I get is 15 or 17 psi. No leaks. Cut ...

...submersible at 130 ft. It is a replacement for an older pump that went bad and is about 8 years old. Yesterday the breaker triped. I turned the breaker back on and it triped after a few minutes of ...

Not finding what you are looking for?
Flotec Corrosion Resistant Shallow Well Jet Pump 1/2HP, 8GPM Logo

177 questions posted

Ask a Question

Usually answered in minutes!

Top Flotec Plumbing Experts

Brad Brown

Level 3 Expert

19187 Answers

john h

Level 3 Expert

29494 Answers

Renee Knafel-Bullock

Level 3 Expert

404 Answers

Are you a Flotec Plumbing Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...