Acer Aspire M1641-U1521A PC Desktop "wires" Questions

...the Power Supply does Not come on, you have a bad Power Supply. The procedure does not involve the wires of the Power On switch, nor the switch itself. The procedure involves using a jumper on the ...

...main power cable is plugged into the motherboard, as shown in the photo to the far right. Where the wires go into the connector, is the back of the connector. The front is plugged into the female ...

...the photo to the far Right. See the Green wire going down into a socket hole? Also view the Black wires going down into the socket holes. The Green wire is the Soft Power On wire. (Also referred to ...

...are connecting the Negative (Black) probe lead of the multimeter, to ANY Ground wire, (ALL Black wires are Ground wires); AND, at the SAME time touching the Positive (Red) probe lead of the ...

...to switch out the motherboard. 1 problem I know I am going to have is to match the front panel plug wires correctly. I can extract the wire pins out . done that before. but the acer really does not ...

... as is the HDD to the serial port of the motherboard, but there is the card reader wire and 2 white wires that i do not know the placements of. you should try to locate a manual for that system and ...

My Aspire M1600 (desktop) might have encountered an overvoltage surge and wont start at all. The lower blue LED on the frontpanel is flashing slowly (1 sec). Where to look /what to do? Looking forward

Which will be good to me???? I have a wireless router Netgear from post office. I want to move my desktop computer to my room but there isn't network cable so what can I do to connect to the internet.

...the green wire, then using the jumper wire, short it with the black wire (there are lots of black wires there). look at the exhaust fan, at this point it should be spinning (good). if not here are ...

...at you. If the front switch isn't sticking I doubt it is that. You can test it by following the wires from the switch to the motherboard, disconnect the wires and use a flat screw driver to make ...