...Toner". When I put the old cyan cartridge back in, the error message goes away (replaced with "Cyan Toner Low"). The printer does not seem to recognize that a new Cyan cartridge has been installed. ...
...toner sensors are diferent. therefore they are usually mixed up, producing the problem just described. If you check your toners and happen to have the correct ones, then have them replaced by your ...
toner lights flashing HiCheck the cartridges for any low or dry cartridges and replace them.Check the cartridges installations and make sure its correctly done.
...Replace toner message. Do an information print (MENU, ENTER, ENTER) This will tell you the pagecount of the various units of the printer Imaging Unit (Drum) Transfer Belt (ITB) Transfer roller Fuser ...
...replace waste toner bin" message appeared. Samsumg responded that I should clean the external sensor (I had advised them that I had tried cleaning the external sensor in my first contact with them). ...
Question about Samsung CLP Office Equipment & Supplies
...replace the toner cartridges, is not correctly closed. Close the top right-hand section first and then close the door on the right-hand side firmly (slamming it if necessary) and then check that all ...
Question about Samsung CLP Office Equipment & Supplies
...replace the toner block (OPC) image drum if you do not have a smart panel install. you may go to www.samsung.com -> support and download the smart panel program. ...
Question about Samsung CLP Office Equipment & Supplies
Replace Transfer Belt" (if it says "Install Transfer Belt" it thinks the belt is NOT installed!)2. I painstakingly went thru every inch of changes I had made to the printer since last running it.
Question about Samsung CLP Office Equipment & Supplies
...check if it is the course. by removing the toner block. pull the belt towards you it shall come out. item to take note on life span for replacement. 1. Fuser - 25K +/- 2. transfer belt - 25K +/- 3. ...
Question about Samsung CLP Office Equipment & Supplies
...cartridge needs a chip, or to be remanufactured. Since it was "refilled", you can get it working again by putting a chip in it. Once the chip is replaced, that reading will go to 100%. The toner on ...
493 questions posted
Usually answered in minutes!
951 Questions
221 Questions
108 Questions
110 Questions
74 Questions