...flow coming from the back of the unit. The air should be about 140 degrees F and forceful. Check to see if the error comes back. If everything runs fine, then you know the problem exists in the vent ...
...flow is good, lint filters clean. Firmware is revision r06. When prompted, the self diagnostic shows error code E04. Anyone have any ideas? Thanks I have the same problem. Does anyone have an
Question about Wascomat Parts Washing Machines
...error code. Your thermocouple is reading high, which could be a multitude of factors. We'll go through them from easy to hard: First, check your dryer vents and make sure they are clean and that you ...
...flow of water into the machine (although with the drain pump also running you won't necessarily see any water building up inside the drum.) I believe the letters actually stand for "Fill
Question about Frigidaire Washing Machines
...error codes E05 and E9E on my dryer. It does still run, but clothes are usually left damp. Air flow is okay Check for clogged exhaust vent. Can you call someone who can help you See below. E95 shows ...
Question about Washing Machines
...error set is related to the dryer overheating, check the vent to the outside to be sure that there is good air flow. Then you have to test some of the devices inside the unit to see if they failed. ...
...and also make sure that water will not over flow to the other side of the washer if this continue it likely to give you an error code then clean up all water that has flow around the water. thank ...
...error message of "ER001" and the lint filter light comes on and the dryer shuts down. I've cleaned the filter, cleaned the sensors, even removed the vent to ensure nothing was obstructing the free ...
...error code e10 and stops. can u tell me what is wrong please? I had this problem, the washer/dryer stopped working while in the drying cycle and displayed e10 message. It was caused by a faulty ...
...flow at the inlet of the water line. Once the water comes into the system the WATER LEVEL SENSOR - normally a pressure switch- must activate at the preset/chosen level to give the signal to the ...
62 questions posted
Usually answered in minutes!
1,845 Questions
401 Questions
404 Questions
243 Questions
245 Questions