LG DLE2512W Electric Dryer "volt getting really hot" Questions

volt / ohm meter to check for Continuity & Volts Its well worth the investment... $15.00 bucks give or take a few I would check to see if you have 220v to back of dryer where the cord mounts to dryer,

volt / ohm meter to check for Continuity & Volts Its well worth the investment... $15.00 bucks give or take a few I would check to see if you have 220v to back of dryer where the cord mounts to dryer,

getting hot they are probably melting the fuse link and not really blowing = fuse box problem. As for most things there are exceptions....a grounded heating element -may- blow the fuse after the dryer

...getting 110 volt instead of 220, and list goes on. Here is a fantastic link, that will take you through every step possible and pictures of inside and where the parts are located to replace. I really ...

...hot and trip the thermal overload switch, you should take the back off the unit and check the belt (really easy just look at it to see if it is around the drum not to tight but tight enough to grip) ...

...getting power at the outlet. Also, if one of the "sides" for the 120 volts shows 0 or a number thats really low, then one of the legs of the circuit breaker is tripped. When you check the circuit ...

...getting 120V across coil and 11ohms but still wont heat up. Dryer coil looks like steel spring, old coil was broken but was much thinner. Could I have the wrong coil? No error code except a clicking ...

...really is not. Your dryer is on a double circuit with two breakers. If one fails you lose one 110 volt leg which can be the one giving the full 220 Volt needed for the heater. This happens quite ...

...hot surface DEVICE... passing over 120 Volts AC (not a recommended process). Simply replacing that VERY INEXPENSIVE item ... got us easily back in service. Again... without a MODEL NUMBER... this is ...

really appreciate some direction helping me solve this problem. Much Thanks Joe. There is a switch mounted on the motors of these dryers that allows the starter windings to be energized when the start