...is most likely bad . Replace. If timer moves on timed dry it is not getting hot enough to click the cycling thermostat.(If clothes are overly hot above 160 then the cycling therm. is stuck
Question about Samsung Dryers
...sounds like the timer is sticking in some cycles and works only in timed dry? as the points in other cycles are seized and stuck close? as for the bulb should be along the back wall of tub or near ...
stuck near the zero time point on the dial); other times it does turn off. If it continues running beyond the cycle point it probably is no longer producing heat and just tumbling. Eventually there is
...time sticks on 54 minutes flashing will start drying then jumps down to 24 minuties select cycle stuck on cotton towels setting....auto temp on high will run through a cycle and dry clothes but the ...
Question about Dryers
...time are stuck and cannot be changed. What's wrong? Try unplugging it for couple minutes and then plug back in to see if problem is fixed if not its probably the mother board i dont the make but i ...
Question about Frigidaire Dryers
not turn on. When on 0 time remaining, I turn the dryer knob to start and it clicks. On other time, it does nothing. turn the start and it's like the drum gets stuck. then starts smelling like burning
...stuck on 21 minutes on sensor dry. Is there a way to reset the time so that it will adjust as necessary using the sensor to ensure all items are dry before shutting off? there is a wire brush that ...
...time the clothes are drying. What could be the problem? Your rear drum bearing is dried up and need to be re-gresed with high temp grease I've got the same problem, but it's not really bad. It's just ...
Question about LG Dryers
...breaker off. Then try again, this might reset controller. Try drying on a timed dry and see if that works. Might have to take apart and give it a good clean Sounds like a stuck relay on the main
...time, clean vent, check flow, had a service tech in to check thermistor- resistance OK, but the exhaust from the vent is no more than 125 degrees(manual says it should be 155 at max timed dry) Tech ...
347 questions posted
Usually answered in minutes!
241 Questions
228 Questions
185 Questions
133 Questions
111 Questions