how do i open the console on my kenmore 800 series washer? THERE ARE TWO SCREWS ON EACH END ON THE BACK OF THE CONSOLE.REMOVE THESE SCREWS. THEN PULL FOREWARD ON THE CONSOLE AND FLIP UP.
remove the back of this dryer? I cannot figure out how to remove the back of this dryer so that I may replace the thermostat. All screws are removed, top is removed, but it seems as though the back is
Question about Kenmore Dryers
...remove the back panel from my Kenmore Gas Dryer, Model # 11073912100 I need to check the Thermal Fuse on my dryer, but the back panel seems to be welded to the main cabinet of the dryer. Hi, Please ...
Question about Kenmore Dryers
...remove the back off my Kenmore 800 series dryer. its electric everything is unplugged. I need to replace the heating element and can not get the back off the dryer!!!! i have tried multiple times in ...
...AT THIS POINT YOU CAN REPLACE THEBELT, IDLER, AND MOTOR MOUNTS. THE 1 EXTRA STEP THE REPLACING THE MOTOR IS TO REMOVE THE BACK AND THEBLOWER COVER THEN UNTHREAD THE BLOWER WHEEL FROM THE MOTOR
...REMOVE THE BACK,YOU WILL SEE THE HEATER BOX TO YOUR LEFT,THERE IS A SMALL FUSE ON THE LEFT SIDE TOP,CHECK THAT IF YOU HAVE A METER,ON THE BOTTOM HALF OF BOX IS THE HEATING COIL,REMOVE THE 2 BOTTOM ...
Question about Kenmore Dryers
...back an the top pop up do the same onthe other side (before you start if you lent filter goes in the top of the dryer remove the two screws holding that down to remove the front in the side panel ...
Question about Frigidaire Dryers
...remove the top to access, but no luck. Called the Frigidaire 800 number and they were no help. Original rep said to use access panel in back, but this is on the opposite side of the drum from the ...
...back of the unit on the lint trap cover on the left there will be a small white fuse with 2 prongs this is called the thermal fuse. There is one quarter inch screw holding it on just remove the screw ...
remove the back cover or if access can be granted to the bottom go there. Find where the heating element(s) connect to the main set of wires and do a continuity test with a multimeter. If it tests bad
289 questions posted
Usually answered in minutes!
287 Questions
241 Questions
185 Questions
133 Questions
111 Questions