...wiring problem. I want to install a tankless electric water heater in a remote bathroom. It requires a 220 V 40 amp service. I have the 2 pole breaker, 8 gauge wire (8/2), and the device. The guy at ...
heater. Could there be something I did wrong on the installation? I followed the directions to the letter and have tried to pinpoint the problem with troubleshooting guide but with no luck. Thanks for
...bathroom. Is the pressure relief valve in the top of the unit where the water was spraying out? Thank you. The T&P valve (temperature and pressure) relief valve is suppose to have a 3/4 in drain ...
heater does not function without remote. Add a comment and say what you did to fix problem. Depending on how old the unit is.....There seems to be a problem with a lot of rheem first generation units.
...the pacific!). You can wire this unit either back to the heater or to wiring from another controller, just match the colours and link them in. Power off the heater first but it is all low
rheem rtg-53pvn will not turn on and heat water when hot water is turned on - no error code - remote just goes off like the power is off Before calling service technician, open following link for ...
Question about Water Water Heaters
Just replaced all my hoses did everything i needed to work on a heater and all went well until I turned on my breaker and the top of the tank where the wires are connected started to smoke water got ...
...heater is flashing an error code of AO and 52. no hot water. what does this mean. This means the solenoid to the modulating gas valve is sharing a fault. You will need to inspect the wiring to the ...
I AM GETTING AN ERROR CODE OF C7 76 ON THE REMOTE WHAT DOES IT MEAN? means that your remote panel is no good. remove cover and disconect the 2 wires. put cover back on and plug in. if that gives you ...
4 questions posted
Usually answered in minutes!
226 Questions
77 Questions
78 Questions