Hayward 1.5 Hp Northstar High Performance Pump "voltage 240" Questions

voltage is coming in 240 volt or 120 volt pump is set from factory for 240 volt look at side of motor if 240 one hot wire to F1 then second hot wire to F2 green to ground if 120 volt see side of motor

...pump see what voltage is coming in 240 or 110 look at schematic on the side of the motor most motors are wired 240 volt if 120 volt you probably will have to change some wires to work on that ...

Hayward stratum won't start pump. It says ac voltage too high. How do I trouble shoot it? I think it is getting 240 volts. Make sure the voltage is set for 240 volts and not 120 volts

...240 volts need to convert to 120 volts Is the motor a Dual voltage capable motor? If so, the diagram for voltage change should be on the label. It is also on the inside of the back cover were the ...

...voltage.. it likely says "120/240 volts".  The 120 uses the low volts diagram and the 240 uses the high volt diagram.  If the motor has terminals L1 and L2, these will most likely be the ...

whats the voltage reading of 230 voltage drive motor put on 220 volt or 240 volt thats the same

...voltage, of 240 V or thereabouts. so, 120 + 120 does not necessarily equal to 40. You could be reading the same voltage back through the motor and getting the exact same voltage on the other hotline. ...

240 volt wiring diagram most common pump motor looks like this, ther can be a black tab just above the top power terminal and if you look close at it you will see printing and a arrow set the arrow to

...voltage you are running as you did not list that information here. Typically a green-red-blue comination of wiring suggests 240 VAC connections. Also, every motor you buy is required to have a wiring ...

...a reset button check incomming voltage make sure pump is set up for correct voltage see side of motor if set up for 240 volt and only have 120 volt that could be the problem also make sure ...