Karcher K2.26 Electric Power Washer "trigger water" Questions

water from trigger i took the trigger apart to check all the o-rings and am left with a small spring. not sure where the spring goes and what is the cause of water leaking out of the handle. any ideas

trigger pulled and the water flowing, the motor will start and stop ok when operating the on/off switch. When operating the pressure is ok and will run continuously Hi Cliff: My experience is that the

...water flow when trigger pressed. Disconnect hoses. Look for kink in water hose. Check incoming water connection for filter washer Replace filter washer If you don't have a filter washer, put one in. ...

...water out of trigger gun with no lance attached, machine switched on. Seems to leak from trigger handle aswell. Many thanks in advance This is two things. One is the back flow check valve to the soap ...

trigger. The water should flow out of the nozzle (without the tip installed) at a faster rate, while the engine noticeably loads down as it used to do before your "no pressure" problem. If it does not

...trigger water gun the pressure blow up,as long as you pull the trigger on the pressure build up pressure it has also equipt with pressure switch to regulate pressure and for safety purpose.you can ...

...water until the trigger is pulled or not. But once the trigger is pulled on the wand the problem goes away. So if you just pull the trigger when turning the water on that should solve your

...water trigger is pressed When the power switch is first turned on it makes a repeating loud noise until the water trigger is pressed and when the trigger is released the same noise starts again Check ...

...trigger no water then motor stops go's completely dead the problem was in the gun, the nipple had broken off the plastic gromit,in the brass part of the trigger mechanism, stopping the water comeing ...

trigger. The water should flow out of the nozzle (without the tip installed) at a faster rate, while the engine noticeably loads down as it used to do before your "no pressure" problem. If it does not