pressure pump after we remove the screws? can you send the diagram? Depends on what pump you are removing. With the nature of the machine being in water all the time the pump could be just frozen onto
Question about Garden
How do I remove the shroud on my Excell XC2600 pressure washer so that I can replace the pulse hose? I am having the same issue. I need to remove the shroud so I can replace the pulse hose. Did you ...
...pressure control valve a "spill valve" is Karcher. On their 3500 units it is under a 3/8" cap screw... which may have a marker seal of yellow or red paint on it. Removal is best ...
no pressure in my power washer the engine is running , the water is coming threw but there is no pressure the problem is that the pump is manufactured with a cheap plastic gear inside the pump which ...
Question about Honda Garden
...pressure washer pump. The shaft spins freely along with the old pump. I am not sure if I need to remove the center shaft bolt. If I'm supposed to remove it, it's stuck and I'm uncertain of which way ...
Question about Karcher Garden
...pressure washer? A Socket set with the correct attatchment for the type of grub screw , the trouble is the hole in the plastic outter casing is too small in diameter to reach the screw Is it a torx ...
Question about Karcher Garden
...pressure pump does switch in If you mean removing the yellow cover then you will need long handled torque screw drivers, these are located at the back of the machine if memory serves me correct, or ...
pressure not power from the washer The sliding valve at the bottom of the unit is stuck, find the cap screw unscrew it and remove the spring and valve clean it and lube it with silicone grease and put
Mitm power washer won!t start Second time used 2700 psi gas model does not have bulb, tried to adjust screw on side, no help the cord is hard to pull you might have left gas in the carb an its ...
...pressure washer pump from engine Removed mounting bolts but can't slide pump off shaft Look closely. There should be a set pin or set screw on the shaft holding it in place. If not you will have to ...
358 questions posted
Usually answered in minutes!
685 Questions
123 Questions
72 Questions
36 Questions
34 Questions