Homelite Consumer Products 9.0 Amp, 14 In. Chainsaw "chain bar brake" Questions

chain off bar over bar tip and towards inward side of bar. Remove two nuts loosened in step 2 and pull brake assembly and bar straight out and off bar mounting studs. While rotating clutch/brake-drum,

...bar and chain on a new 445.can not replace clutch cover after following instructions closely.it seems brake is on. WOULD REALLY APPRECIATE HELP. THANKS. You'll definitely have to unlock the chain ...

...bar & chain on, the three hole line up easily but how do i get the brake back on the clutch? The proper sequence to installing the chain should be to first ensure the brake is in the 'unlocked' ...

...bar. The chain is correctly tensioned when it does not sag from the underside of the bar, but can still be turned easily by hand. Hold up the bar tip and tighten the bar nuts with the combination ...

bar/chain and clean the entire assembly, particularly the small oil passages in the drive end of the bar. Start the engine and watch for oil oozing out of the small side port where the bar fits. If ok

...chain, the bar groove and the sprocket nose on the bar. A burr on the drive links will bind the chain in the bar. If the bar has been pinched, the chain will not pass freely through the groove. If a ...

...installing the chain and replacing the bar cover the chain will not move freely Have you got chain brake on Also check the chain brake if it is on pull the chain brake handle back and turn it

...chain brake and bar cover from my 51/55 Husquarna saw and cannot get the cover back on the saw. The brake band is to tight to fit over the clutch assembley and I cannot figure out how to get to ...

bar and chain because it is so much easier to unlock it mounted on the saw if yours is the design that comes off with the cover. Keeping the front of the bar elevated during assembly and adjustment of

...chain guide (bar) is pinched. I think the chain brake is engaged. Most Echo have extremely good OMs, please consult yours. Grasp the most forward upper handle. Move it toward the bar nose and it ...